Steady Custom Cycles Bull Horn handlebar was designed and created give your bike a unique style and appearance. Typically most handlebar designs would start out with a wide lower section, however the Bull Horn starts narrow on the bottom and widens up as it goes towards the top.  This gives it a signature design, original to Steady Custom Cycles under Patent Pending #515804374.

Bull Horn Handlebar for Harley Davidson Specs:

• Available rise: 12″ – 18″ (for different rises that isn’t listed, please contact us!)
• Pullback:8-1/2″
• Width: 38″
• Tube diameter: 1-1/2″ tapered to 1″ on hand control areas
• Clamp diameter: 1″ and 1-1/4″ (for 2014+ Road Glide)

Features:

• Unique and custom design only available from SCC (Patent Pending #515804374)
• Sturdier and stronger than OEM handlebars
• Internal wiring ready (NOT pre-wired)
• Pre-Machined slots for Throttle-By-Wire (TBW) and clamp positioning pin
• Will work with hydraulic or cable clutch

If your bike has individual top/upper handlebar clamps, single solid top/upper clamps are *required* to run all handlebars with a rise of 12″ and higher. Solid or stiffer (polyurethane) handlebar bushings are highly-recommended.